Brick Pavers
Paver Walkways & Walls
Walkways get judged up close. Every cut is at eye level, every joint is visible, and a path that has settled half an inch reads as neglect from the street.
We lay entry walks, garden paths and pool-side routes on the same compacted base we use under driveways, and we run lighting conduit before the pavers go down so the path can be lit later without cutting it open.

What's included
- Layout marked on site and walked with you before we dig
- Compacted limestone base over geotextile fabric
- Paver or concrete edge restraint on both sides
- Soldier-course or contrasting borders where the design calls for it
- Steps, risers and landings on graded ground
- Empty conduit for future path lighting
- Polymeric sand joints, compacted twice
- Bed edging and sod repair along the finished path
Typical investment
{{TODO-OWNER: typical walkway price range, per linear or square foot}}
Quoted after a site visit — length, width, curves, steps and material set the number.
Warranty
{{TODO-OWNER: workmanship warranty term}}
Workmanship coverage in writing, plus the manufacturer's warranty on the pavers.
How it works
From marked layout to lit path
- 1Week 1
Site visit & layout
We mark the route on the ground with paint and walk it with you before anything is dug.
- 2Week 1–2
Design, samples & fixed quote
Paver, border and pattern selected from physical samples, with a width that suits how the path is actually used.
- 31–2 weeks lead
Materials & scheduling
Shorter lead than driveways — walkway quantities are small enough that stock is usually available.
- 4Day 1
Excavation & base
Trench cut to depth, fabric down, base compacted in lifts, and conduit laid for lighting.
- 5Days 1–3
Laying & cutting
Pavers set to pattern with the cuts pushed to the edges, and edge restraint pinned along both sides.
- 6Final day
Sand, compact & walkthrough
Joints sanded and compacted, beds tidied, and a walkthrough with you.
Materials & brands
Belgard, Tremron and Pavestone all make smaller-format pavers suited to paths, where a big driveway-scale unit would look coarse. Clay brick suits older Freeport and DeFuniak Springs houses better than concrete does.
Path pavers do not carry vehicle loads, so thinner profiles are fine — but the base underneath is built the same way.
Built for here
What walkways are up against here
Sand washing out from the edges
A path without edge restraint spreads sideways in sand within a couple of seasons. We pin restraint along both sides of every walkway, which is the single biggest difference between a path that stays tight and one that does not.
Roots and canopy
Live oaks and mature palms lift paths over time. We route around the critical root zone where we can and use a root barrier where we cannot, rather than cutting roots and losing the tree.
Lighting done in the right order
Running conduit under a finished walkway means cutting it open. We lay empty conduit during the base stage on every path, so lighting can be added later for the cost of the fixtures rather than the cost of a rebuild.
Walkway questions
How wide should a walkway be?
Four feet lets two people walk side by side, which is the right width for a main entry walk. Garden paths work at three feet, and anything narrower starts to feel like a service route.
Can you build steps into a sloped path?
Yes. On graded lots in DeFuniak Springs and Inlet Beach that is common. Steps are built on the same compacted base with solid risers rather than stacked pavers.
Will the path settle where it meets the driveway?
Not if both were built on a proper base. Where a new path meets an old driveway we compact the transition carefully, because that joint is where movement shows first.
Can you add lighting to an existing walkway?
Yes, though it means trenching alongside the path rather than under it. It is far cheaper on a path we built, because the conduit is already there.
What about weeds in the joints?
Polymeric sand hardens and resists them. Growth that does appear later has almost always germinated in debris sitting on top of the joint rather than pushing up through it.
Do you build seat walls and borders too?
Yes — low seat walls, planter borders and pillar bases are part of this work. Anything structural or over about three feet is on our retaining walls page.
Planning a walkway or entry walk?
Send photos of the route and we'll tell you what it takes to build it straight and keep it that way.


